WIKA CPH6300 Benutzerhandbuch
Seite 17
6 Commissioning, Operation
WIKA Operating Instruction, Model CPH6300 17
14043054
.01
07
/20
12
G
B/
D
Menu
Parameter
Value
Description
or
Set Alarm: Settings for alarm function
On/No.So
Alarm Sensor 1 on, with/without buzzer
OFF
No alarm function for Sensor 1
Sensor1-Min
... AL.1-Hi
Min-alarm-limit sensor 1 (not if AL.1 = oFF)
Sensor1-Min is lower display range limit of sensor 1
AL.1-Lo ...
Sensor1-Max
Max-alarm-limit sensor 1 (not if AL.1 = oFF)
Sensor1-Max is upper display range limit of sensor 1
On/No.So
Alarm Sensor 2 on, with/without buzzer
OFF
No alarm function for Sensor 2
Sensor2-Min
... AL.2-Hi
Min-alarm-limit sensor 2 (not if AL.2 = oFF)
Sensor2-Min is lower display range limit of sensor 2
AL.2-Lo ...
Sensor2-Max
Max-alarm-limit sensor 2 (not if AL.2 = oFF)
Sensor2-Max is upper display range limit of sensor 2
On/No.So
Alarm on, with/without buzzer (1-channel version) or
Alarm sensor difference on with/without buzzer
(2-channel version)
OFF
No alarm function (1-channel version) or
No alarm function for sensor difference (2-channel vers.)
-19999 …
AL.DIF-Hi
Min-alarm-limit difference (not if AL.DIF = oFF)
***
Sensor-Min
... AL.Hi
Min-alarm-limit sensor (not if AL. = oFF)
Sensor-Min is lower display range limit of sensor
AL.DIF-Lo …
19999
Max-alarm-limit difference (not if AL.DIF = oFF)
***
AL.Lo ...
Sensor-Max
Max-alarm-limit sensor (not if AL. = oFF)
Sensor-Max is upper display range limit of sensor
Set Logger: Settings for logger function
*
Selection of logger function
*
CYCL
Cyclic: cyclic logger
Stor
Store: manual recording
oFF
No logger activated
0:01 ... 60:00 Cycle time in [minutes: seconds] (for cyclic logger)
*
on/oFF
Low-power-logger with low power consumption
(only for cyclic logger and slow measuring rate)
*
Set Clock: Settings for real time clock
HH:MM
Clock: set time hours: minutes
YYYY
Year: set year
TT.MM
Date: set date day. month
rEAd Logg: Read calibration data:
seechapter 6.5.1
(*)
If logger memory contains data sets parameters marked with (*) cannot be called. You have to
clear memory to change these parameters! (see chapter 6.5)
(**)
Parameter can only be called if corresponding sensor is plugged to connection 1. The settings
are applied to the sensor at connection 2 (if any connected).
(***)
Only 2-channel version
GB