Emerson Process Management El-O-Matic E and P Series E25-E950 - Handbuch (Seite 22)

Data sheet
Copyright © Emerson Process Management. The information in this document is subject to change without notice.
Updated data sheets can be obtained from our website
www.El-O-Matic.com or from your nearest Valve Automation Center USA: +1 813 319 0266 Europe: +31 74 256 10 10 Asia-Pacific: +65 6501 4600
www.El-O-matic.com
Description
EL-O-MATIC CSR-actuators have an excellent corrosion resistance in environments where the actuator is
in contact with chemicals like caustic soda. The CSR coating itself is resistant to at least 1000 hours of salt
spray test exposure. Together with the excellent mechanical properties, the CSR coating is "the" solution for
very harsh environments.
CSR actuator housing and caps are completely coated (inside and out) with a ceramic filled fluoropolymer
based epoxy resin, impregnated by a temperature of 240°C into the aluminum surface.
Approximately 40% of the coating is impregnated into the aluminum, 60% stays on the surface of the
component as a seal.
Technical data
Coating
: Ceramic filled fluoropolymer based epoxy resin
Layer thickness : 20 microns
Salt spray test : DIN 50021 / ASTM B117: 1000 hours
Max. temperature : -4° to 176°F (20° to + 80°C)
Materials : Housing : Aluminum alloy
: Shaft : Aluminum hard anodized
: (Option : Stainless steel)
: Fasteners : Stainless steel
: Tagplate : Stainless steel
Application : Optional on all EL-O-MATIC actuators
Chemical resistances
Resistance to various inorganic chemicals, organic chemicals, gasolines, oils, detergents,
etc. is generally good to excellent, but also depends on temperature and/or concentration.
More detailed information available at data sheet A4.204.021
A4.204.02 Rev.B EL-O-MATIC ACTUATOR WITH CSR COATING CSR
CSR
Corrosion
Protected
Hard anodized aluminum
(Option : Stainless steel)
Stainless steel fasteners
Coating:
20 microns Ceramic filled epoxy resin
Sheet No.:
Date: June 2009