Kenwood TS-780 - Handbuch (Seite 6)

3-l. FRONT PANEL
1 F. LOCK Indicator
This indicator will light when the LOCK switch is turned ON
(VFO frequency is locked).
2 B U S Y I n d i c a t o r
This indicator lights when the squelch is open in FM or.FM-
CH receive mode, allowing the Operator to check whether
the other Station is transmitting.
3 O N A I R I n d i c a t o r
This indicator will light during transmission.
4 O F F S E T I n d i c a t o r
This indicator lights when the TX OFFSET switch is set to
the D A or D - B Position for repeater Operation.
5 M e t e r
This meter has four functions, each being selected by using
the meter select switch.
RFIS: The meter serves as “S” meter indicating the
strength of received Signal on a scale graduated
from 1 to 10 (FM), or 1 to 9, 9+20 dB and
9+40 dB (SSB CW).
2
3
4
5
6
7
8
9
10
1 1
1 2
13
14
15
16
1 7
18
19
2 0
2 1
22
23
24
2 5
26
27
28
2 9
3 0
3 1
32
33
3 4
35
36
37
38
39
4 0
F. LOCK Indicator
BUSY Indicator
ON AIR Indicator
OFFSET Indicator
Meter
TX-OFFSET Switch
REV (Reverse) Switch
TONE Switch
LOW POWER Switch
NB (noise
blanker) Switch
Meter Switch
VOX Switch
Standby Switch
POWER Switch
MIC Connector
PHONES
Jack
MODE Switch
PRIO. M Switch
TIGHT Level
F. STEP Indicator
Tuning Knob
FUNCTION Switch
MEMORY Selector
S S B M I C
RIT Indicator
RIT Control
IF SHIFT Knob
S Q U E L C H C o n t r o l
SCAN-W
AF GAIN Control
RF GAIN Control
F. STEP Switch
RIT Switch
SCAN Switch
H O L D
M. S Switch
BAND Switch
M (Memory) Switch
F. LOCK Switch
M. R (Memory Recall)
Switch
During transmission, the meter indicates RF
output.
ALC/CEN: In FM receive mode (MODE switch in FM, FM-
CH position), the meter functions as a Center
meter. T u r n t h e V F O k n o b t o y o u r d e s i r e d
r e c e i v e Signal u n t i l t h e meter pointer i s
centered.
In other operating mode (SSB, CW), the meter
indicates the transmitter ALC voltage. In SSB
Operation, adjust the MIC gain control so that
the meter pointer deflects within the ALC zone
on the scale. In CW Operation, adjust the CAR.
L knob.
6 T X - O F F S E T S w i t c h
This switch is used to shift the TX frequency from the RX
frequency for repeater Operation. After the repeater opera-
tion, it should be set to the SIMP Position; the TX frequen-
cy will coincide with the RX frequency. In case of Off-band,
the frequency is not shifted and the transceiver is set in
simplex mode.
5