T+A Elektroakustik PA 820 M - Handbuch (Seite 34)

34
Remote control of the pre-amplifier and power amplifier
General information
In the illustration shown alongside the buttons marked
"
   “ are those which are required for remote control
of the pre-amplifier and power amplifier. None of the
other buttons has any effect on the pre-amplifier or
power amplifier.
    The ON button (    ) on the remote
control handset switches the system on and
off.
When you switch on, the volume is always
limited to "room level“.
    The brightness of the screen can be
adjusted to suit the lighting level in the
system’s location.
• Hold the     button pressed in for
about 3 seconds until you see the
message '
BRIGHT X BRIGHT X BRIGHT X BRIGHT X ' on the screen.
• Press the     /     to set the desired
brightness level.
• If you make no change for about
3 seconds, the screen reverts to normal
brightness.