T+A Elektroakustik PA 820 M - Handbuch (Seite 35)

35
Selecting the listening source
A brief press on a source button selects the corres-
ponding device as listening source. The signal from this
source is then reproduced by the system. If the system is
switched off, it is automatically switched on if you press a
source button.
You can only remotely control that device which is cur-
rently selected as the listening source. The listening
sources are selected using the following buttons on the
remote control handset:
    CD 820 M CD player or DVD 820 M DVD
player
    Toggles between Tape 1 / Tape 2
    The PT 820 M’s integral tuner
    Source device connected to the pre-amplifier
input AUX / PHONO
    Toggles between the source devices which
are connected to the pre-amplifier inputs
AUX / TV and STB (if connected to the
DD 820 M).
Notes:
• When you change sources, the newly selected
source is displayed briefly on the screen. The screen
then reverts to a device-specific standard display.
• If your system includes an MM or MC module,
AUX / P is the phono input.
• The signal from the currently selected source is
present at the TAPE record outputs, and can be
recorded onto cassette or other form of tape.
Volume control
   

  
Every time you press one of the VOLUME
buttons briefly, the volume is reduced (-) or
increased (+) by 1.5 dB.
If you hold one of the VOLUME buttons
pressed in for longer than about 1 second,
the volume changes continuously until you
release the button again.
The current volume level is displayed on the
screen briefly as a numeric value (0 … 63),
e. g.:
' VOLUME VOLUME VOLUME VOLUME 32 32 32 32 '
Loudspeaker output     A /     B
    The loudspeaker groups    A und    B are
switched on by pressing this button
repeatedly.
The new status is briefly displayed on the
alpha-numeric screen, e. g.: '
SP SP SP SP A A A A '
A long press switches the loudspeaker
outputs off.
The current status of the loudspeaker out-
puts is also shown on the screen constantly
in the form of the code letters A and B.
Notes:
The loudspeaker outputs remain switched off
during the first few seconds after the system
is switched on, (power-on delay).
If you select the loudspeaker mode A+B (Bi-
wiring: see 'Appendix, wiring diagram
1b'), the loudspeaker outputs cannot be
switched on and off separately.