IMP Pumps NMT(D) LAN (C) 40-100 & NMT SAN LAN (C) flanges - Handbuch (Seite 30)

-30-
GB
Key
Short press:
• Scrolling through parameters upwards when not changing parameter
values,
• Scrolling through modes upwards when mode selection is selected,
• Changing parameters upwards when setting parameter values.
• Long press:
• 5 seconds together with and keys to restore pump to factory
settings.
5.1.1.2 Turning on and off
On first start up the pump will operate with factory settings in automatic mode.
With subsequent start-ups, the pump will operate with the last settings that
were set prior to its shut-down.
To switch the pump off, press and hold the key for 5 seconds, until OFF is
shown on the display. When the pump is switched off, the numerical display
shows OFF.
To turn the pump on, press the key briefly.
5.1.1.3 Pump modes and parameters
For transition between modes, we hold the key for 3 seconds and then
select the mode in which we wish the pump to operate with or keys. We
confirm the selection with the key.
After confirming the mode, the parameter, which can be set, will automatically
be displayed and blink (except for auto mode). If necessary, we set the
parameter value with and keys, and then confirm the setting with the
key or just press the key to accept the given parameter.
We can scroll through the parameters within a mode with and keys. We
select the parameter that can be adjusted (see individual mode) in the mode
with the key and set the desired value with and keys. We confirm the
selected value with the key.
5.1.1.4 Setting the pump to the factory settings
To restore factory settings to the pump, it is necessary to press and hold
all three keys for 5 seconds. The pump is set to the automatic mode of
operation. The previously set values for pressure and speed will be deleted.