WolfVision VZ-C32 User Manual - Handbuch (Seite 17)

DVI-I Port
1 - T.M.D.S. Data2- 9 - T.M.D.S. Data1- 17 - T.M.D.S. Data0-
2 - T.M.D.S. Data2+ 10 - T.M.D.S. Data1+ 18 - T.M.D.S. Data0+
3 - T.M.D.S. Data2/4 Shield 11 - T.M.D.S. Data1/3 Shield 18 - T.M.D.S. Data0+
4 - T.M.D.S. Data4- (*) 12 - T.M.D.S. Data3- (*) 19 - T.M.D.S. Data0/5 Shield
5 - T.M.D.S. Data4+(*) 13 - T.M.D.S. Data3+ (*) 20 - T.M.D.S. Data5- (*)
6 - DDC Clock 14 - +5V Power 21 - T.M.D.S. Data5+ (*)
7 - DDC Data 15 - Ground (return for +5V, 22 - T.M.D.S. Clock+
8 - Analog Vertical Sync HSync and Vsync) 23 - T.M.D.S. Clock-
C1 - Analog Red 16 - Hot Plug Detect 24 - Analog Vertical Sync
C4 - Analog Horizontal Sync C2 - Analog Green C3 - Analog Blue
C5 - Analog Ground *...not used
(analog R, G & B return)
m
Pin 24
Pin 8
Pin 1
Pin 9
Pin 17 C4
C1 C2
C3
C5
15
The Ceiling Visualizer is fitted with an automatic lamp changer.
If one lamp fails, there is no need to replace it immediately, as the automatic lamp changer
automatically switches to the second (spare) lamp. When the unit changes lamps there is
an on-screen message saying: "Changing lamp".
When switching on the unit the Visualizer checks if both lamps are working. If one lamp fails
there will be an on screen message for a couple of seconds displaying "Lamp x blown".
This prevents a user from forgetting to change a defective lamp.
Automatic Lamp Changer
If the unit gets too hot (improper ventilation or air extraction) a built in thermostat will switch
off the light of the Visualizer. Verify that proper ventilation and air extraction is available and
allow the unit to cool.
Thermostat
In some rooms the 3 built-in infrared receivers of the Ceiling Visualizer may not be enough.
In this case connect the supplied external infrared receiver to the IR-sensor plug (#17) and
position the IR-sensor somewhere on the ceiling (or in the room) where the users normally
point the remote control at.
IMPORTANT External Infrared (IR) Sensor
Lightbox (optional)
When a lightbox is used, the top light of the Visualizer should be switched off
with the assigned PRESET key (LIGHT).
Using a bottom light has the disadvantage that the Synchronized Lightfield of the top light
no longer marks the pick-up area of the built-in camera.
The recommended lightbox for the Ceiling Visualizer is the WolfVision Lightbox LB-38.