Installing the shelf supports, 2 pyrolysis, 3 oven lamp – Electrolux EOC6851BAX Benutzerhandbuch

Seite 36

Advertising
background image

2

1

2.

Pull the rear end of the shelf support
away from the side wall and remove
it.

Installing the shelf supports

Install the shelf supports in the opposite
sequence.

The rounded ends of the shelf
supports must point to the front.

12.2 Pyrolysis

CAUTION!
If a hob is installed with the appli-
ance, do not use it at the same
time as the Pyrolysis function. It
can cause damage to the appli-
ance.
For steam models only: before
you start the cleaning procedure,
make sure that the water tank is
completely empty. Refer to “Emp-
tying the water tank”.

Remove all accessories from the
appliance.

The cleaning procedure cannot start:
• If you do not close the appliance door

correctly.

• If you do not unplug the core tempera-

ture sensor (if present).

When the Pyrolysis starts the ap-
pliance door is locked. After the
function finishes the door is
locked for the cool down phase.
Some of the appliance functions
are not available during the cool
down phase.

WARNING!
When the Pyrolysis finishes the
appliance is very hot. Let it cool
down. There is a risk of burns

Pyrolysis :

1.

Remove the worst of the residual dirt
manually.

2.

Activate the appliance and choose
the Pyrolysis function in the main
menu. Press OK to confirm.

3.

Touch

or

to set the length

for the procedure:
– Quick - 1h for a low degree of dirt
– Normal - 1h 30 min for a usual de-

gree of dirt

– Intense - 2h 30 min for a high de-

gree of dirt

4.

Press OK to confirm.

12.3 Oven lamp

WARNING!
Be careful when you change the
oven lamp. There is a risk of elec-
trical shock.

Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or

deactivate the circuit breaker.

Put a cloth on the bottom of the
oven to prevent damage to the
oven light and glass cover.
Always hold the halogen lamp
with a cloth to prevent grease res-
idue from burning on the lamp.

1.

Turn the glass cover counterclock-
wise to remove it.

2.

Clean the glass cover.

3.

Replace the oven light bulb with an
applicable 300 °C heat-resistant oven
light bulb.
Use the same oven lamp type.

4.

Install the glass cover.

36 www.electrolux.com

Advertising