WIKA CPP1000-H - Handbuch (Seite 6)

Hand test pump GB
CPP 700-H / CPP 1000-H
WIKA Operating Instructions Hand test pump Version 1.3 6
3. Mounting instructions .
 The reference instrument is fitted to the upper side of the hand test pump CPP 700-H or
CPP 1000-H. The reference instrument is sealed by the integral O-ring sealing gasket. The
maximum torque is 15 Nm.
 The unit under test is mounted to the end of the flexible test hose. Tighten to the connector to
prevent any leaks to a maximum torque of 15 Nm.
Never apply external pressure to the CPP 700-H and CPP 1000-H. Do not
connect to external pressure sources.
 As an accessory, several stainless steel sets of adapters are available to cover different thread
dimensions of your test specimen.
 Tighten the optional adapters to a maximum torque of 15 Nm.
Tip: It is possible to connect the test specimen directly to the pump. After dismounting
of the hose connector, there is a 1/4" BSP female thread at the side of the pump body.
 Open the filling plug (3) of the liquid reservoir (6) and fill with a suitable fluid:
mineral oil based hydraulic fluid or clean water, free of calcium-carbonate / scale.
(Not suitable for hydraulic oils based on water and destilled water.)
 Fill the liquid reservoir (6) not completely full