Chariot Carriers 2003 Benutzerhandbuch

Seite 16

Advertising
background image

Press the fabric cover at the
front outward over the side
frame tubes, until the hole in
the frame tube is exposed.

Working from the front
(between the fabric and the
side frame tube), lay the
aluminium profile of the
telescopic tube on top of the
side frame tube and, still
working from the front, insert
the counter sunk bolt through
the holes in the aluminium
profile and side frame tube.

Using a Philips crosshead
screwdriver and an 11mm
spanner, screw on the nylok
nut and tighten gently.

Attach the aluminium profile of
the telescopic tube to the
other side of the trailer in
exactly the same way.
Tighten both nylok nuts fully.

Fitted telescopic tube, shown
from inside the trailer.

Fitted telescopic tube, shown

from the front.

Rear view of the baby seat with fastex insert and unit that fits the
fastex buckles on the safety belts of the Chariot CTS trailers.

1.2 Securing the Baby Seat

The baby seat can be either fitted to one side or in the centre.
For side fitting both ends of the seat belt of the appropriate side are needed and for centre fitting
both centre ends of both seat belts.

For this the fastex unit on the end of the right belt (as seen in the direction of travel) and the fastex
insert on the end of the left belt (as seen in the direction of travel) must be attached.

16

Fastex insert and unit for
side fitting.

Fastex insert and unit for

centre fitting.

Advertising