Chariot Carriers 2003 - Handbuch (Seite 17)

17
If the fastex buckle components need to be refitted the other way round (e.g. for fitting the baby seat
in the centre), thread the end of the belt through as illustrated.
Remove the padded shoulder harness by unthreading it from the
strap fasteners on the back rest. For fitting the baby seat in the
centre, both shoulder straps must be removed.
1.2.1 Preparing the safety belts
1.2.1.1 On luxury models
1.2.1.2 On standard models
Loosen the shoulder harness at the fastex buckle on the back
rest.
Then guide the tensioning strap supplied through the lateral flaps
that are at the bottom towards the front and pull it very tight. The
tensioning strap and flaps should be positioned in front of the
vertical frame tubes, when viewed from the inside of the
transporter.
As regards the Captain XL and Corsaire XL models, in the final version there is a problem when
fitting the Chariot baby seat in line with the fitting instructions as stated, in that its final position is too
low. This would mean that the baby might come into contact with the seat of the transporter itself.
Contrary to the current fitting instructions, please ensure that you fit the Chariot baby seat to the
Captain XL and Corsaire XL models as follows:
Follow all steps up to (and inclusive of) section 1.2.1 of the fitting instructions
1.2.1.3 only for the Captain XL and Corsaire XL models