Chariot Carriers 2003 Benutzerhandbuch

Seite 19

Advertising
background image

19

Insert both belt ends of the
shoulder harness through
either the two lower or the two
upper slots in the baby seat,
depending on the size of the
child.

Thread the belt ends
protruding from the rear of the
baby seat though the fasteners
on the back rests of the trailer
seat, as on the illustration.
The fasteners are
appropriately at their lowest
setting.

1.2.2 Securing the baby seat to the trailer seat

Connect the fastex buckles on
the baby seat with their
counterparts on the seat
belt - for side fitting, these are
the ends of the belt on the
appropriate side and for centre
fitting, these are the ends of
the belt in the centre.

The baby seat is properly fitted
if the side of the flap for the
crotch harness padding that is
attached to the baby seat
points towards the front of the
trailer.

Experience has shown that it helps if approximately the following overall belt length adjustment is
made (measured from the point of attachment to the baby seat to the point of attachment to the
trailer seat):

For the models with floor pan - Captain XL, Captain and Comfort - about 12cm
For all others - 15 or 16cm

In the illustration, the slots for feeding through the shoulder harness described in the next section
can also be seen.

1.2.3 Fitting the safety belts

1.2.3.1 On luxury models

The Chariot baby seat is properly fitted when the front padding is
in a near vertical position above the telescopic tube after all
straps have been pulled tight.

Advertising