Chariot Carriers 2003 - Handbuch (Seite 18)

18
Place the Chariot baby seat in
the transporter. Lay both the
straps that are attached to the
bottom of the baby seat
around the tensioning strap
that you have fitted, and thread
the end through as shown in
the illustration A.
Centre-fitting:
This should then give a distance of about 8 cm (3 inches) between the baby seat and the tensioning
strap.
Pull the baby seat upwards
between the fitted telescopic
tube and the front fabric
assembly or the front wall of
the floor pan, and place it in
the internal space of the
transporter.
Make sure that the front padding of the baby seat is positioned above the
telescopic tube.
Side-fitting:
Only the baby seat strap that faces the middle is to be fastened to the tensioning strap, fitted as
described above. Then the baby seat is pulled around the telescopic tube.
The outside-facing baby seat strap that is between the vertical
frame tube and the fabric cover should be guided around the
vertical frame tube, then under the telescopic tube, and finally
back up between the telescopic tube and the fabric cover.
Then in both cases follow steps 1.2.2., 1.2.3., 1.2.5. and 1.2.6. of the fitting instructions.
Inside view
Thread through the end of the
strap as shown in the above
illustration and pull the strap
tight. The easiest way of getting the
strap tight is by pulling the end
of the strap downwards below
the seat.
Illustration A