Chariot Carriers 2003 - Handbuch (Seite 24)

24
2.2.3 Fitting the safety belts
See Section 1.2
2.2.4 Securing the lower end of the baby seat
Insert the belt of the baby seat
through the D ring. Thread the strap through as
illustrated... ...and pull the strap tight.
Fit the second belt on the other side in the same way.
2.2.5 Securing the upper end of the baby seat
Lay both the straps that are at the top of the baby seat around the top crossbar inside the trailer.
Thread the straps through and pull them tight firmly.
See illustrations in Section 1.2.5.2
We recommend folding the basic unit slightly for this step, so as to slacken off the fabric cover.
Make sure you do not pull the straps too tight, otherwise once you fold the unit out again the baby
seat will be under too much tension.
2.2.6 Final step in fitting the seat
Pull all fastening straps tight.
If you want to adjust the seat to a flatter position, loosen both of the top fastening straps and pull the
other four straps tight; for an adjustment of greater incline, the procedure is the same but reversed.
Please note:
Make sure you check all belt buckles are tight!
Fully fitted baby seat.