Chariot Carriers 2003 - Handbuch (Seite 22)

22
Lay both the straps that are at
the top of the baby seat around
the top crossbar inside the
trailer. Thread the strap through as
illustrated... ...and pull the strap tight.
1.2.6 Final step in fitting the seat
For the sport models (Cougar, Cheetah) we recommend folding the basic unit slightly for this step,
so as to slacken off the fabric cover. In addition we recommend here not pulling the straps too tight,
otherwise once you open the unit out again the baby seat will be under too much tension.
Pull all fastening straps tight.
If you want to adjust the seat to a flatter position, loosen both of the top fastening straps and pull
the other four straps tight; for an adjustment of greater incline, the procedure is the same but
reversed.
Fitted baby seat ready to use in the centre and side position.
Please note:
Never transport your children
without the safety belts being
properly and fully adjusted,
otherwise your child could be
seriously or even fatally
injured in the event of an
accident!
Centre-fitting:
Thread both straps that are on the back rest through the fasteners on the baby seat as described
above.
Lay the strap that is on the side
of the baby seat facing out of
the trailer around the vertical
frame tube at the side and over
the horizontal diagonal tube
and pull it forward again.
Thread the strap as described
above through the fastener
and pull the strap tight.
1.2.5.2 On all other two seaters
Please note:
Make sure you check all belt buckles are tight!