AMT Datasouth Fastmark M4 - Handbuch (Seite 30)

~ 30 ~
Printer initialization
Printer initialization is used to clear DRAM and restore printer settings to defaults.
1.
Turn off the printer power switch.
2.
Hold on the FEED button ( ) then turn on the power switch ( ).
3.
Release the power switch ( ) when LED color turn on amber,
continue pressing the FEED button.
4.
The printer will beep twice, then release the FEED ( ) button when the
battery LED indicates and blinking. The LED will sequence
right to left, 5 blinks each.
5.
The printer will restore printer settings to defaults
Self-test and Dump Mode
Follow the steps below to calibrate the media sensor.
1.
Turn off the printer power switch.
2.
Hold on the FEED button ( ) then turn on the power switch ( ).
3.
Release the power switch ( ) when LED color turn on amber,
continue pressing the FEED button.
4.
The printer will beep twice, then release the FEED ( ) button when the
battery LED indicates and blinking. The LED will sequence
right to left, 5 blinks each.
5.
The printer will calibrate the sensor and print out the internal settings,
then enter the DUMP mode. Turn the printer OFF/ON to exit DUMP
mode.
Power-ON Utility for standard panel
Follow the steps below for different power-ON utilities.
1.
Turn off the printer power switch.
2.
Press down the FEED button ( ) then turn on the power switch ( ).
3.
Release the power switch ( ) when
“Error” LED turns to red, continue
pressing the FEED button.
(With LCD Display)