AMT Datasouth Fastmark M4 - Handbuch (Seite 31)

~ 31 ~
4.
The printer will beep twice, then release the FEED ( ) button when the
LCD indicates
the desired function; “Calibrate” or “Self-test” or “Initialize”.
 Turn the printer OFF/ON to exit utility mode.
Self-test
The printer will print the printer configuration after media sensor calibration. Self-
test printout can be used to check if there is any print head dot damage, printer
configurations and available memory space.
Printer initialization Media sensor
calibration, self- test
and enter DUMP
Mode
Media sensor
calibration
Release FEED
button for
different functions
LCD
(5 dots) (5 dots) (5 dots)
Power ON Utilities
Standard Panel
LCD Configurations
Self Test.. … Calibrate.. …
Initialize.. …
Printer model name & Main board firmware version
Printer serial number
Printed mileage
Main board firmware checksum
Serial port setting
Code page
Country code
Print speed
Print darkness
Label size (width, height)
Gap/Black mark (vertical gap, offset)
Sensor sensitivity
Battery voltage
Print head temperature
Print head average resistance Bad dots of print head
Bad print head dots
Bluetooth settings information
WiFi settings information
File management information
Print head test pattern
}
}
}
}