AMT Datasouth Fastmark M4 - Handbuch (Seite 32)

~ 32 ~
Dump Mode
The printer will enter dump mode after printing the configuration page. In the
dump mode, all characters will be printed in 2 columns as following. The left side
characters are received from your system and right side data are the
corresponding hexadecimal value of the characters. It allows users or engineers
to verify and debug the program exceptions.
 Dump mode requires 4” wide paper width setting.
 Turn off / on the power or press FEED button to
resume printer for normal printing. (Ready mode)
Printer defaults
Printer configuration will be restored to defaults as below after initialization.
ASCII Data Hexadecimal Data
Parameter Default setting
Speed 50.8 mm/sec (2 ips)
Density 8
Media Width 4” (101.5 mm)
Media Height 4” (101.5 mm)
Sensor Type Gap sensor
Print Direction 0
Reference Point 0,0 (upper left corner)
Gap Offset 0
Post-Print Action Tear mode
Serial Port Settings 9600 bps, none parity, 8 data bits, 1 stop bit
Code Page 850
Country Code 001
Clear Flash Memory No
Media Calibration:
Perform media calibration when completing the Initialization. Turn
ON the printer and open/close the media cover.