AMT Datasouth Fastmark M4 - Handbuch (Seite 44)

~ 44 ~
Print mode
This item is used to set the print mode. There are 3 modes as below,
Batch
Mode
Offset
This item is used to fine tune media stop location. Available setting
value is from
“+” to “-” or “0” to “9”.
+000
Shift X This item is used to fine tune print position. Available setting value is
from “+” to “-” or “0” to “9”.
+000
Shift Y +000
Reference X This item is used to set the origin of printer coordinate system horizontally
and vertically. Available setting value is from
“0” to “9”.
000
Reference Y 000
Code page Use this item to set the code page of international character set. 850
Country Use this option to set the country code. 001
Printer
Mode
Description
None
Next label top of form is aligned to the print
head burn line location. (Tear Off Mode)
Batch Mode
Once image is printed completely, label
gap/black mark will be fed to the tear plate
location for tear away.
Peeler Mode Enable the label peel off mode.
NOTE:
If printing from enclosed software/driver, the
software/driver will send out the commands, which
will overwrite the settings set from the panel.