Guntermann & Drunck HardBoot CCX - Handbuch (Seite 31)

Guntermann & Drunck GmbH HardBoot CCX
Installation and Configuration Manual
Page 15
4 Turn Target On/Off using AdonIS
In the CATCenter Adonis Operation menu, you can turn the currently active
target on/off in the line 'TARGET POWER'.
The base requirements for this function are:
 At least one HardBoot must be connected to the CATCenter to supply
power.
 The corresponding settings must have been set for this target in the
'CONFIG-Menu -> Power' (see
Chapter 3 ).
To turn off a target, carry out the following steps:
1. Access AdonIS by pressing the key combination (default):
CTRL + NUM
2. Access the OPERATION menu by pressing the F9 key.
3. Move the cursor to the entry 'TARGET POWER' and press ENTER or
the I key.
By pressing the ENTER key, the selected (and running) target is automatically
turned off.
After the target has been turned off, the entry in the 'TARGET POWER' line
changes from On to Off.
Follow the same process to turn on a target that is not running.
Alternatively, the function can be called from the SELECT menu using the
hotkey combination CTRL + I.