Dolby Laboratories DVD & MP3 - Handbuch (Seite 19)

19
DVD PLAYER OPERATION
2-CHANNEL ~ 5.1-CHANNEL SETUP
■ When the unit is set to 2-channel mode, pressing the [4/2-6CH] button for a longer period
of time will set the mode to 5.1 channel. This will be indicated on the LCD display with
“FULL 6CH”.
Note:
■ The volume of 2-CH and 5.1-CH modes is controlled and stored independently. Before
you switch to 5.1-CH mode, lower the volume and also check the input gain settings of
your external amplifier, to avoid nasty surprises!
PAUSE & PLAYBACK
■ Press the [PAUSE] button to pause playback.
■ Press it again to resume normal playback.
START & STOP PLAYBACK
■ Press the [ENTER/PLAY] button to start playback of the disc.
■ Press [6/STOP] button to stop playback of the disc.
SKIP PLAYBACK
■ Press the [ ] button to skip to the next track/chapter and playback from there.
■ Press the [ ] button to skip backwards to the previous section/chapter and begin play-
back from there.
Note:
■ When a VCD disc is loaded and PBC is turned ON, this function will not work.
REPEAT PLAYBACK
■ Press the [5/REPT] button once to repeat playback the current Chapter/Track.
■ Press it once more to repeat playback of the whole Title/Disc.
■ Press it a third time to cancel the repeat playback function.
RANDOM/SCAN PLAYBACK
■ Repeatedly press the [3/P.MODE] button to switch among Random/Scan and Normal
playback modes according to the following sequence: Random Scan Normal
■ The “Scan” playback function will play the beginning of each track for roughly 10 sec and
then continue to play the next track/section.
SELECT CHAPTER/TRACK OR PLAY TIME
■ Press the [GOTO] button on the remote control to select the play time (for CD/VCD) or
select the desired chapter (for DVD).
■ Then press the direction button to select different content or use the numeric keys to
enter a chapter number or time data (if there is no operation within 5 sec, the unit will exit
this mode.)
■ In DVD mode, press the button again to select playtime of the title, which will be indicated
on monitor.
Note:
■ If you’re using CD discs, you can also directly press a number button on the remote con-
trol to select a certain track, and you don’t need to press the [GOTO] button first, to use
this function.
ZE-200DVD Manual E+D_c.indd 19 ZE-200DVD Manual E+D_c.indd 19 26.05.2004 14:28:25 Uhr 26.05.2004 14:28:25 Uhr