EverFocus EKR-KB1 - Handbuch (Seite 99)

Page 97 MNNCEKRKB1_0439
6.15 Santec Do me
6.15.1 Connection
6.15.1.1 Cable
White
Yellow
RS485A
RS485B
TX +
TX -
6.15.1.2 Setting up the dome
The dome number and protocol should be correctly configured. The baud rate can be selected between: 2400
(default), 4800, 9600 baud. Consult the dome manual.
6.15.1.3 Setting up the keyboard
While configuring the keyboard, the submenu  , should have the
following settings:




The baud rate should correspond to the one chosen for the
dome.
6.15.2 Configurati on
Dome configuration is mostly carried out using the On Screen Menu.
For all dome setup operations the keyboard should be enabled for TELEMETRY CONFIGURATION (menu
 ).
6.15.2.1 OSM Configu ration
Directly connect the dome to the keyboard as shown in the diagram and a monitor to the dome video output.

start dome configuration.
The dome shows the on screen menu; the keyboard display shows the mode change:




end of configuration.
The ESC key required by dome configuration procedure is replaced by the

key.
Important note! When exiting dome configuration it is necessary to press
 
to return the keyboard to normal
operation.
Joystick  : cursor movement within the menus
 : replaces the CTRL key.
 : replaces the ESC key.