Eppendorf 5810 R Centrifuge - Handbuch (Seite 61)

61
Centrifuge 5804/5804 R/5810/5810 R — Operating manual
6.4 Saving the program
You can save the current centrifugation parameters and functions (At set rpm, acceleration and
braking times and radius) under up to 35 program numbers.
Prerequisites
Rotor stop.
6.5 Loading the program
Prerequisites
• Rotor stop.
6.6 Deleting the program
Prerequisites
• Rotor stop.
• The centrifuge lid is open.
1. Check the parameters and functions to be saved.
2. Press key twice.
The first free program number appears with P... in the display.
3. Select the program number ( 1 ... 9 , A ... Z ).
4. Press and hold key for 2 seconds.
ok appears in the display. The current centrifugation parameters and functions are
saved under the selected program number.
Hint!
When you want to overwrite a saved program, you have to delete it before saving the new
parameters (see Deleting the program on p. 61).
1. Press once.
Program number flashes:
• 0 : centrifugation parameters and functions of the last run.
• 1 ... 9 , A ... Z : stored programs.
2. Select the program number.
3. Closed centrifuge lid: centrifugation starts with the loaded centrifugation parameters
and functions.
When the centrifuge lid is open, you can press the start/stop key to return to
program 0 or exit the programming mode.
Hint!
If you change the centrifugation parameters during a run with a stored program, the centrifuge
changes to program
0 . The stored program remains unchanged.
You can also exit the stored program by loading program 0 .
1. Press once.
The program number flashes.
2. Select the program number.
3. Within 10 seconds, keep key pressed for 2 seconds
The following text appears in the display: cleared .
The selected program is deleted. You can save new centrifugation parameters and
functions under this program number.
EN
Operating manual