WIKA TR30 - Handbuch (Seite 6)

GB
6 WIKA operating instructions model TR30
11377551.06 07/2014 GB/D
2. Safety
WARNING!
Before installation, commissioning and operation, ensure
that the appropriate resistance thermometer has been
selected in terms of measuring range, design, specific
measuring conditions and appropriate wetted parts' materials
(corrosion).
Non-observance can result in serious injury and/or damage
to the equipment.
Further important safety instructions can be found in the
individual chapters of these operating instructions.
2.1 Intended use
The resistance thermometer model TR30 is used as general-purpose
thermometer for the measurement of temperatures from -50 … +150 °C
(without neck tube) and -50 … +250 °C (with neck tube) in liquid and
gaseous media. It can be used for pressures up to 40 bar (special
designs to 400 bar dependent on insertion length and diameter).
The instrument has been designed and built solely for the intended use
described here, and may only be used accordingly.
The technical specifications contained in these operating instructions
must be observed. Improper handling or operation of the instrument
outside of its technical specifications requires the instrument to be taken
out of service immediately and inspected by an authorised WIKA service
engineer.
If the instrument is transported from a cold into a warm environment, the
formation of condensation may result in the instrument malfunctioning.
Before putting it back into operation, wait for the instrument temperature
and the room temperature to equalise.
The manufacturer shall not be liable for claims of any type based on
operation contrary to the intended use.
2. Safety