Lenze DriveServer Erste Schritte - Handbuch (Seite 60)

DriveServer
L
58 DriveServer DE/EN 1.1
6.2 Access via OPC clients
The DriveServer can be accessed by the following software components which serve as OPC clients
and have been optimised for Lenze controllers:
• The DriveServer configuration tool which has already been described in the previous chapter.
• The parameter setting program Global Drive Control with OPC interface (as of version 4.3).
• ActiveX controls, which can be integrated into your application.
6.2.1 DriveServer configuration tool
You have already used the program “DriveServer configuration tool” to configure the DriveServer.
( ^ 52)
The DriveServer configuration tool is an OPC client, which expects the DriveServer to be an OPC server.
If your system is configured as described in chapter 5, you can access the name area of the DriveServer
system using the DriveServer configuration tool:
1. Select
Programs W Lenze W DriveServer W DriveServer configuration tool.
2. Select the corresponding DriveServer from the tree structure and click Connect.
– The DriveServer will be started. The drives connected to the assigned bus servers are
identified and listed in the name area.
The following figure shows a part of a name area for a system consisting of a “9300 Servo inverter”
which is connected to the DriveServer via LECOM:
Show/Hide Bookmarks