Retsch AS 450 control - Handbuch (Seite 16)

Transport, scope of delivery, installation
16
• Use the two C1 screws to screw connector C to port B13.
Pos : 6. 21 /00005 Ü berschrif ten/ 1. 1 Ü bersc hrift en/ 1. 1 Übersc hrift en BD A/ 11 Wandmont age der Bedi enei nheit @ 0\ mod_1231317922078_9.doc @ 5470 @ @ 1 Pos : 6. 22 /00010 Bedi enungsanleit ung en Kapitels ammlungen/ AS450_c ontrol/ 0006 Tr ans port, Liefer umf ang und Aufst ellen /AS450 M od ul Wandmont age der Bedienei nheit @ 0\ mod_1231317976333_9. doc @ 5476 @ @ 1
Fig. 3: Wall-mounting of the control panel
On the back of the control panel B there is a wall mounting plate BW. The wall
mounting plate BW has an upper and a lower engaging position.
For wall mounting you need 4 screws (maximum diameter 4mm) and 4
corresponding dowels.
• Press the wall mounting plate upwards or downwards depending on the
engaging position.
• In the central position, the disengaged wall mounting plate can be taken out
of the BH holding frame.
• Use the wall mounting plate as a template for marking the four required
boreholes.
• Use all four BL holes when fastening the wall mounting plate.
When screwing on the wall mounting plate, make sure the flat surface is pointing
towards the wall.
Pos : 6. 23 /00005 Ü berschrif ten/ 1. 1 Ü bersc hrift en/ 1. 1 Übersc hrift en BD A/ 11 El ektrisc her Ansc hlus s @ 0 \mod_1226565067445_9. doc @ 3500 @ 2 @ 1
4.9 Electrical connection
Pos : 6. 24 /00004 Warnhinweis e/ W0008 WARNUN G Stroms chl ag nic ht vollst ändig eing est ec kt em Kal tgeräte-N etzs tec ker ( AS450) @ 3\ mod_1282727985935_9. doc @ 22697 @ @ 1
WARNING
2.W0008
Risk of death through power surge
Mains plug not completely plugged in
–
Water can enter the IEC socket if the IEC is not completely plugged in. An
electric shock can lead to burns and arrhythmia or to respiratory arrest as
well as cardiac arrest.
• Only operate the device with the IEC fully plugged in.
Pos : 6. 25 /00003 St andard Kapit el/ General M odul Elektrischer Ans chl uss @ 0\ mod_1228918538521_9.doc @ 4731 @ @ 1
WARNING
When connecting the power cable to the mains supply, use an external fusethat
complies with the regulations applicable to the place of installation .
• Please check the type plate for details on the necessary voltage and
frequency for the device.
• Make sure the levels agree with the existing mains power supply.
• Use the supplied connection cable to connect the device to the mains power
supply.
Pos : 6. 26 /00010 Bedi enungsanleit ung en Kapitels ammlungen/ AS450_c ontrol/ 0006 Tr ans port, Liefer umf ang und Aufst ellen /AS450 M odul ext erne Absic herung @ 1\ mod_1243926877257_9. doc @ 10394 @ @ 1
B
BW
BH
BL