Operating the machine, 12 switching on interval or continuous mode – Retsch AS 450 control Benutzerhandbuch
Seite 25
Operating the machine
25
5.11.1 Activating the Undefined Sieving time
Two bars appear in the display (At) if the time is reduced to less than 1 minute or
increased to more than 99 minutes.
The undefined sieving time is activated in this way.
Pos : 7. 25 /00005 Ü berschrif ten/ 1. 1 Ü bersc hrift en/ 1. 1 Übersc hrift en BD A/ 11 I nt er vall oder D auer betri eb @ 0\ mod_1229419427823_9. doc @ 5094 @ @ 1
5.12 Switching on interval or continuous mode
Pos : 7. 26 /00010 Bedi enungsanleit ung en Kapitels ammlungen/ AS450_c ontrol/ 0007 Bedienung/ AS450 M odul Inter vall-Betrieb @ 0\ mod_1229419914048_9.doc @ 5100 @ @ 1
Fig. 13: Interval operation
•
Use the (B7) key to turn on the interval operation.
–
The interval on LED lights up over the (B7) key.
•
Use the + key (B10) to increase the interval time up to 99 seconds.
On exceeding 99 seconds, the display starts again at 10 seconds.
•
By pressing the - key (B9), you can reduce the interval time down as far
as10 seconds.
When the time is reduced to less than 10 seconds, the display starts again at 99
seconds.
5.12.1 Switching Off the Interval
•
Press the (B8) key to switch off the interval operation.
–
The interval off LED lights up over the (B8) key.
–
The display (Ai) goes out.
Pos : 7. 27 /00005 Ü berschrif ten/ 1. 1 Ü bersc hrift en/ 1. 1 Übersc hrift en BD A/ 11 Memor y
– Speic her n und Abr ufen von Siebpar ameter n @ 0\mod_1229422683591_9.doc @ 5106 @ @ 1
5.13 Memory
– Saving and calling-up sieving parameters
Pos : 7. 28 /00005 Ü berschrif ten/ 1. 1. 1 Ü bersc hrift en/ 111 St arten eines g es peic her ten Programms @ 0\ mod_1229424036698_9. doc @ 5118 @ @ 1
5.13.1 Starting a saved program
Pos : 7. 29 /00010 Bedi enungsanleit ung en Kapitels ammlungen/ AS450_c ontrol/ 0007 Bedienung/ AS450 M odul Progr amm Modus akti vi eren @ 0 \ mod_1229422715446_9. doc @ 5112 @ @ 1
Fig.14: MEMORY display
The MEMORY function, i.e. the storage or retrieval of preselected sieve
parameters, can be utilised only in the stand-by mode. You can change and
overwrite the P1 to P9 program places at any time.
B1
B2
Am
B7
B8
Ai
B9
B10