Retsch AS 450 control - Handbuch (Seite 26)

Operating the machine
26
– “on” appears in the display as soon as the AS450 is switched on.
• By pressing the PROG (B1) key, you can move to the next program place
P1 to P9.
After program place P9, the on appears in the display again. In the PROG mode all
keys are blocked apart from PROG (B1), START (B11) and STOP (B12).
In the standard mode “on” appears in the (Am) display and you can freely adjust all
sieve parameters.
In PROG modes P1 to P9 you can save and call up the sieve parameters.
• Press the start key to start the sieving process with the selected program .
Pos : 7. 30 /00005 Ü berschrif ten/ 1. 1. 1 Ü bersc hrift en/ 111 Programme s peic hern @ 0\ mod_1229424145211_9.doc @ 5124 @ @ 1
5.13.2 Saving programs
Pos : 7. 31 /00010 Bedi enungsanleit ung en Kapitels ammlungen/ AS450_c ontrol/ 0007 Bedienung/ AS450 M odul Progr amme speichern @ 0\ mod_1229424181960_9. doc @ 5130 @ @ 1
Fig. 15: Saving Programs
• Press the PROG (B1) key until the desired memory location P1-P9 is
reached.
• Press the SET key (B2).
– All displays flash.
• Set the amplitude mm/”g”, time min and interval time sec sieving
parameters.
The programming modecan be stopped by pressing the PROG (B1) key and the
values will not be saved then.
• Press the key SET (B2) to save the entered values.
The display flashing stops, the adjustment lockis activated and the sieving
parameters are saved.
If the AS450 is controlled by a PC and the “Easy Sieve® “ sieve software, “ES”
appears in display 2.
In this mode it is not possible to make any manual changes to the sieving
parameters.
Pos : 7. 32 /00005 Ü berschrif ten/ 1. 1 Ü bersc hrift en/ 1. 1 Übersc hrift en BD A/ 11 Sc hwi ngungs höhe eins tell en @ 0\ mod_1229432006343_9. doc @ 5136 @ @ 1
5.14 Setting the amplitude
Pos : 7. 33 /00005 Ü berschrif t en/1.1 Ü bersc hriften/1.1 Übersc hriften BD A/11 Sc hwi ngungs höhe i n „ mm“ @ 1\mod_1236330299407_9.doc @ 7740 @ @ 1
5.14.1 Amplitude “mm”
Pos : 7. 34 /00010 Bedi enungsanleit ung en Kapitels ammlungen/ AS450_c ontrol/ 0007 Bedienung/ AS450 M odul Sc hwing ungs höhe eins tellen @ 0\ mod_1229433455694_9.doc @ 5160 @ @ 1
B1 B2
Am