Retsch AS 450 control - Handbuch (Seite 23)

Operating the machine
23
• Place the quick clamp device on the sieve cover so that the sieve rod is
enclosed (See Fig. 1).
• Twist the green handle on the quick clamp device until it is located over the
red handle (see Fig. 2)
5.7.2 Clamping the Sieve Stack
Using the quick clamp device it is now possible to clamp the sieve cover and
thereby the sieves tightly onto the device.
• Repeat these steps with the second quick clamp device.
• Twist both quick clamp devices until the sieves are tightly and securely
clamped by the sieve cover.
5.7.3 Securing the Quick Clamp Device (Locking)
Locking secures the quick clamp device on the sieve rod.
• Finally twist only the green handle a little further until the quick clamp device
is locked.
• Repeat this step with the second quick clamp device.
Pos : 7. 17 /00005 Ü berschrif ten/ 1. 1 Ü bersc hrift en/ 1. 1 Übersc hrift en BD A/ 11 Bedienung des G erät es @ 0\ mod_1229416465774_9. doc @ 5052 @ @ 1
5.8 Operating the Device
Pos : 7. 18 /00004 Warnhinweis e/ V0006 VOR SICHT G ef ahr von Pers onensc häden G ef ährlic he Stof fe @ 1\ mod_1236238456269_9. doc @ 7634 @ @ 1
CAUTION
Danger of personal injury
Dangerous nature of the sample
–
Depending on the dangerous nature of your sample, take the
necessary measures to rule out any danger to persons.
• Observe the safety guidelines and datasheets of your
sample material.
Pos : 7. 19 /00005 Ü berschrif ten/ 1. 1 Ü bersc hrift en/ 1. 1 Übersc hrift en BD A/ 11 Ei n- / Aussc hal ten @ 0\ mod_1229416527496_9.doc @ 5058 @ @ 1
5.9 Switching On and Off
Pos : 7. 20 /00010 Bedi enungsanleit ung en Kapitels ammlungen/ AS450_c ontrol/ 0007 Bedienung/ AS450 M odul Ei n- Aussc halten neu @ 4\ mod_1330080568655_9. doc @ 26835 @ @ 1
Fig. 11: Switching on/off
The main switch (H) is on the left side of the AS450.
• Switch the main switch on.
– on lights up in the memory display.
– The last set vibration amplitude, e.g. 1.00. lights up in the amplitude display
H