Baumer BA_DDBF - Handbuch (Seite 17)

DDBF_BA_V2_0.doc 33/44 Baumer Electric AG
05.09.07/rut Frauenfeld, Switzerland
PEAK 127 kN
CH A 125 kN
DMS1 324 uE
DMS2 350 uE
1: 324 2: 350
CH A 337 kN
1: 250 2: 272
CH B 261 kN SUM 598 kN
PEAK 601 kN
CH A 337 kN
CH B 261 kN
Comment:
S/G1 (DMS1) or S/G2 (DMS2):
The strain values of the individual
strain gauges of the selected
channel in
µε (e.g. CH A)
Comment:
1 or 2: The strain values of the
individual strain gauges of the
above channel in
µε ( µ m/m).
Comment:
SUM: If the unit kN or t is chosen,
the sum of both channels is
displayed.
PEAK: Displays the peak value
of SUM.
4.10.3 Display DDBF 4-Sx
Note:
If the value exceed the maximum of “9999”, “OVFL” is shown on the Display.
For a valid indication in kN or t the calculation parameters must be set correctly.
Default Display in [ µε ] Display at selected Unit [kN] or [t]
AVG 223 uE
PEAK 451 uE
A 220 B 226
C 220 D 226
SUM 2300 kN
PEAK 3450 kN
A 570 B 580
C 574 D 576
Comment:
AVG: Average of the active channels
PEAK: Displays the positive peak value of AVG.
CH A to D: Strain value of the corresponding
channel in
µε ( µ m/m).
If a channel is not activated „----“ is shown.
Comment:
SUM: Sum of all active channels.
PEAK: Displays the positive peak value of SUM.
CH A to D: measuring value of corresponding
channel in kN or t.
If a channel is not activated „----“ is shown.
DDBF_BA_V2_0.doc 34/44 Baumer Electric AG
05.09.07/rut Frauenfeld, Switzerland
5 Programming
5.1 Selecting Parameter
PROG
ESC
PARA 1
DISPLAY CH1
PARA 3
RESET ENABLE
CH1 235 uE
1: 233 2: 237
PARA 5
CALC PARA
PARA 6
OUTPUT 1
PARA 7
OUTPUT 2
PARA 4
UNIT uE
PARA 2
CHANGE-POL OFF
PARA 8
Channel Select
Set up display
(in the case of the DDBF 4-Sx this indication
does not appear)
Activate change of polarity
Deactivate function of Reset button
Set up display unit
Set calculation parameters
Select analog outputs
(only in case of DDBF 4-Sx)
Select analog outputs
(only in case of DDBF 4-Sx)
Select channels
(only in case of DDBF 4-Sx)
Note:
After the “Prog.” Button is pressed, in the case of the
DDBF 2-SC “PARA1” (set up display) appears, and
in the case of the DDBF 4-Sx “PARA2” (change
polarity) appears.
“Prog” With this, the user goes from measured value display to parameter selection.
“Esc” With this, the user returns to measured value display without saving the settings.
Select the parameter to be changed.