Baumer BA_DDBF - Handbuch (Seite 20)

DDBF_BA_V2_0.doc 39/44 Baumer Electric AG
05.09.07/rut Frauenfeld, Switzerland
5.6.3 Setting hole diameter d
ENTER
ESC
PROG
CALC PARA
d = 000 mm
CALC PARA
d = 001 mm
CALC PARA
d = 009 mm
CALC PARA
d = 000 mm
CALC PARA
d = 010 mm
CALC PARA
d = 090 mm
CALC PARA
d = 200 mm
CALC PARA
d = 000mm
CALC PARA
d = 100 mm
CALC PARA
d = 200 mm
CALC PARA
d = 900 mm
................. .................
.................
Note:
Setting range 0 … 599 mm
(The hole diameter must be at least 2 mm smaller than the shaft diameter)
“Enter” To switch from CALC PARA/d to the setting area
“Esc” Back to CALC PARA/d without saving the setting
“Prog.” Back to CALC PARA/d saving the setting
To increment the flashing digit
To decrement the flashing digit
To select the digits to be adjusted (the digits then flash)
DDBF_BA_V2_0.doc 40/44 Baumer Electric AG
05.09.07/rut Frauenfeld, Switzerland
5.7 Analog output
Caution:
If the red LED is on an error occurred. In this case the analog output goes to overflow or underflow.
OVFL:
+1,2V UNFL: -1,2V
5.7.1 Analog OUT1
ENTER
PARA 6
OUTPUT 1 CH B
ESC
PROG
OUTPUT 1
CH A
OUTPUT 1
CH B
OUTPUT 1
CH C
OUTPUT 1
CH D
OUTPUT 1
AVG
“Enter” To switch from PARA6 into analog
output 1 selection
“Esc” Back to PARA6 without saving the
setting
“Prog.” Back to PARA6 saving the selected
setting
To select analog output 1 setting
Note:
This setting applies only to the DDBF 4-Sx.
In the case of the DDBF 2-SC, channel 1 (CH A) is always shown at output 1 (analog OUT1) and channel 2
(CH B) is correspondingly shown at output 2 (analog OUT2).
5.7.2 Analog OUT2
ENTER
PARA 7
OUTPUT 2 CH B
ESC
PROG
OUTPUT 2
CH A
OUTPUT 2
CH B
OUTPUT 2
CH C
OUTPUT 2
CH D
OUTPUT 2
AVG
“Enter” To switch from PARA7 into analog
output 2 selection
“Esc” Back to PARA7 without saving the
setting
“Prog.” Back to PARA7 saving the selected
setting
To select analog output 2 setting
Note:
This setting applies only to the DDBF 4-Sx.
In the case of the 2-channel device, channel 1 (CH A) is always shown at output 1 (analog OUT1) and
channel 2 (CH B) is correspondingly shown at output 2 (analog OUT2).