Setup menu, Preparations for using the setup menu, Installing the device driver – Guntermann & Drunck MultiPower-6 Benutzerhandbuch
Seite 20
Setup menu
5 · MultiPower-6
Setup menu
With the setup menu, you can view and change the settings of the
MultiPower-6
.
You can operate the setup menu in any terminal emulator (for example HyperTerminal
or PuTTY).
Preparations for using the setup menu
Before calling up the setup menu, you need to install a device driver on the computer
to address the Service socket and establish a connection in the terminal emulator.
Installing the device driver
Before establishing a connection in the terminal emulator, install the device driver
CP210x USB to UART Bridge VCP
.
The driver provides the Service socket (connected by using the service cable) as vir-
tual serial interface (COM port). You can select the virtual interface in the terminal
emulator to establish a connection.
How to install the device driver to address the Service socket:
1. Open the website
www.gdsys.de
in a web browser.
2. Go to
Downloads > Drivers &Tools
.
3. Download the device driver
CP210x USB to UART Bridge VCP
for the computer’s oper-
ating system.
4. Execute the file and follow the instructions given in the installation wizard.
Setup Menu for MultiPower-6
Show Firmware Info
...
Show Temperature Info
...
Show Load Info
...
Show Power Out Info
...
Set System Defaults
...
Power Start Delay:
0,7 s
Power Channel Delay:
0,1 s
Left/Right: Toggle S:Save