Crivit H14347 - Handbuch (Seite 8)

8 GB/IE
Safety / Before you start / Getting started
- strong vibrations,
- heavy mechanical loads,
- direct sunlight,
- moisture / rain.
Otherwise there is a danger that the
device will be damaged.
J Please note that the guarantee does not
cover damage caused by incorrect han-
dling, non-compliance with the operating
instructions or interference with the device
by unauthorised individuals.
J Under no circumstances should you take
the device apart. Improper repairs may
place the user in considerable danger.
Repairs should only be carried out by
specialist personnel.
Safety Instructions
for Batteries
J Remove the batteries from the device if
they are not going to be used for a
prolonged period.
J CaUTION! DaNGEr OF
EXPLOSION! The batteries
must never be recharged!
J Make sure that the polarity is correct
when you insert a battery. This is indicated
in the battery compartment
13 .
J If necessary, clean the batteries and
device contacts with a dry cloth before
inserting the batteries.
J Insert the battery type CR2032 and the
four batteries type LR44 into the device.
Otherwise the pedometer will not work
properly.
J Remove spent batteries immediately from
the device. There is an increased danger
of leaks!
J Batteries must not be disposed of in the
normal domestic waste!
J Every consumer is legally obliged to dis-
pose of batteries in the proper manner!
J Keep batteries away from children; do
not throw them in the fire, short-circuit
them or take them apart.
J If the above instructions are not complied
with, the batteries may discharge them-
selves beyond their end voltage. There is
then a danger of leaking. If the batteries
have leaked inside your device, you
should remove them immediately in order
to prevent damage to the device!
J Avoid contact with the skin, eyes and mu-
cous membranes. Any parts of the body
coming into contact with battery acid
should be rinsed off with copious amounts
of water and / or a doctor contacted if
necessary!
J Only use the type of battery specified.
Q
Before you start
Q
removing the isolating strip
The batteries are already installed in the
device on delivery.
j Pull the insulating strip at the back of the
appliance off in the direction indicated by
the arrow. An acoustic signal will sound.
Your pedometer is now ready to be configured.
Q
Getting started
Before using the device for the first time, you
have to set the following parameters: unit of
measurement (metric or US system), length of
step, body weight, height, age, sex, time unit
(12-hour/24-hour clock), current time, alarm