AEG 40006VS-MN - Handbuch (Seite 30)

INSTALLATION
WARNING!
Refer to "Safety information"
chapter.
TECHNICAL DATA
Dimensions
Height 847 - 867 mm
Width 596 mm
Depth 600 mm
Oven capacity 74 l
LOCATION OF THE
APPLIANCE
You can install your freestanding appli-
ance with cabinets on one or two sides
and in the corner.
A
A
B
Minimum distances
Dimen-
sion
mm
A 2
B 685
LEVELLING
Use small feet on the bottom of appliance
to set the appliance top surface level with
other surfaces.
ANTI-TILT PROTECTION
CAUTION!
You must install the anti-tilt pro-
tection. If you do not install it, the
appliance can tilt.
Make sure you install the anti-tilt
protection at the correct height.
1. Set the correct height and area for
the appliance before you attach the
anti-tilt protection.
2. Install the anti-tilt protection 77 mm
down from the top surface of the ap-
pliance and 49 mm from the left side
of the appliance into the circular hole
on a bracket (see fig.). Screw it into
the solid material or use applicable
reinforcement (wall).
3. You can find the hole on the left side
on the back of the appliance (see
fig.).
Lift the front of the appliance (1) and
put it in the middle of the space be-
tween the cupboards (2). If the space
between the bench cupboards is larg-
er than the width of the appliance,
you must adjust the side measure-
ment to centre the appliance.
Make sure that the surface behind the
appliance is smooth.
30 www.aeg.com