JUMO 707030 dTRANS T03 2-Wire/3-Wire Transmitter Operating Manual - Handbuch (Seite 60)

16
3 Setup program
The setup program is available for calibrating/configuring the trans-
mitter from a PC. Connection is through the PC interface with USB/
SPI converter (including adapter) and the setup interface of the
transmitter.
3.1 Hardware and software requirements
The following hardware and software requirements must be met for
installing and operating the setup program:
- IBM-PC or compatible PC
- 256 MB main memory
- 50 MB available on hard disk
- CD-ROM drive
- 1 free USB interface
- Windows 2000, XP, Vista, Windows 7 (32 bit or 64 bit)
3.2 Adjustable / configurable parameters
- TAG number (8 characters)
- Response to probe break/short-circuit
- Range start, range end
- Total lead resistance (out/return conductor)
for 2-wire circuit
- measuring range configuration in °C or °F
H
In order to calibrate/configure the transmitter, it has to be
connected to the supply. If no supply unit or supply isolator
is available, Types 707030/..., 707031/... and 707032/... can
be powered by a 9V block battery.