Baumer NE218 - Handbuch (Seite 31)

NE218
www.baumer.com 31
4 Operating mode
The operation and use of the counter are described in the section.
● As soon as the power supply has been switched on, the counter
is automatically set to the operating mode.
In the operating mode:
-the current counter status can be read and reset;
-the preset values P1, P2 can be read and reset;
-the start count SC can be read and reset;
-the totalizer ∑ can be read and reset;
-the time meter can be read and reset;
-the scaling factor SF can be read and reset;
All the parameters can be disabled in the programming mode.
4.1 Key functions
Parameter readout The key allows to switch to the next operation parameter.
For quick sweep, keep the key depressed.
Resetting of counts 1. Display count of respective parameter.
2. Press the key.
Setting of parameters 1. Display parameter.
2. Press the key and select required decade;
chosen decade position blinks.
3. Press the key and enter required value.
To set further decades, repeat steps 2 and 3.
4. Confirm the parameter entered with .
Should no confirmation be given within 15 s, then the previous
setting will remain valid.
Reset
Current main counter status
After the counter has been turned on or upon selection via , the
current count is displayed for reading.
The LED „XP“ shines.
➜ Read the counter status XP.
➜ Press the key.
Change
Preset value P1
➜ Press the key.
The preset value P1 is displayed for reading.
The LED „P1“shines.
➜ Enter the preset value P1 via and keys.
Press the key.
Change
Preset value P2
➜ Press the key.
The preset value P2 is displayed for reading.
The LED „P2“shines.
➜ Enter the preset value P2 via and keys.
Press the key.