Sharp AL-1651CS - Handbuch (Seite 153)

AL-1651CS ELECTRICAL SECTION 14 - 3
6) PC side: Check that trees are displayed on "Special (MCU/IMC2/
Facsimile" in the integration maintenance program. (If trees are not
displayed, check that the USB cable is connected and select
"Reconnect" again in procedure 5).
7) PC side: Double-click "Special (MCU/IMC2/Facsimile)" in the main
tree items to develop its sub trees. Select "Get Version" in the sub
trees.
8) Check that the following display is shown.
With the above procedures, version acquisition is completed.
• The display of "**.**" means its version is not downloaded. The
downloaded versions are displayed in a version number as shown in
"MCU Boot Version: 00.08."
Note: For models without FAX, the facsimile data version is not down-
loaded and always displayed as "**.**."
3. EEPROM data acquisition procedure
EEPROM data is acquired to the PC. Use this procedure as data main-
tenance of EEPROM.
1) Main unit side: Press and hold [CA] key and [LEFT(V)] key, and turn
on the power simultaneously. (Check that "DOWNLOAD MODE" is
displayed on the operation panel of the main unit.)
2) Connect the machine and the PC with a USB cable.
3) PC side: Boot "Mainetenance.exe" and select "JUGUAR2" in the
"Select Model" menu.
4) PC side: Check that "test command list" tree is displayed in the inte-
gration maintenance program.
5) PC side: Boot the integration maintenance program. If "The copier
is not turned on." is displayed on the lower side of the display,
select "File"
→ "Reconnect" on the menu bar.
6) PC side: Check that trees are displayed on "Special (MCU/IMC2/
Facsimile" in the integration maintenance program. (If trees are not
displayed, check that the USB cable is connected and select
"Reconnect" again in procedure 5).