Burkert Type 4040 - Handbuch (Seite 4)

2 - 4040
english
ATTENTION EXERCISE CAUTION ON
HANDLING ! ELECTROSTATICALLY
SENSITIVE COMPONENTS / MODULES
The unit contains electronic components that are very sensitive to
electrostatic discharge (EDS). Contact to electrostatically charged
persons or objects will endanger these components. In the worst case,
they will be immediately destroyed or will fail after commissioning.
Observe the requirements of EN 100 015 - 1 in order to minimize the
possibility of, or avoid, damage from instantaneous electrostatic
discharge. Also take care not to touch components that are under
supply voltage.
Please observe the notes in these operating instructions together with the conditions of use and permitted
data that are specified in the data sheets of the type 4040 in order that the device will function perfectly and
remain operable for a long time:
• Keep to standard engineering rules in planning the use of and operating the device!
• Installation and maintenance work are only allowed by specialist personnel using suitable tools!
• Observe the current regulations on accident prevention and safety for electrical devices during operation
and maintenance of the device!
• Switch off the supply voltage in all cases before intervening in the system!
• Note that in systems under pressure, piping and valves may not be loosened!
• Take suitable precautions to prevent inadvertent operation or damage by unauthorized action!
• After interruption of the electrical or pneumatic supply, make sure that start-up of the process takes place
in a well-defined, controlled manner!
• On non-observance of these notes and unauthorized interference with the device, we will refuse all liability
and the warranty on device and accessories will become void!
General Safety notes
Protection from damage by electrostatic charging
Scope of delivery
Immediately after receiving the shipment, ensure that the contents are undamaged and correspond to the sco-
pe of the delivery listed on the enclosed packing note. In case of discrepancies, please immediately contact
your Bürkert Service department or our service department:
Bürkert Steuer- und Regelungstechnik, Service Department
Chr.-Bürkert-Str. 13-17, D-74653 Ingelfingen
Tel.: (07940) 10-111 / Fax: (07940) 10-448
E-Mail: [email protected]
Symbols
ATTENTION!
marks notes on whose non-observance your health or the functioning of the device will be
endangered.
NOTE marks important additional information, tips and recommendations.
The following symbols are used in these operating instructions:
marks a work step that you must carry out
GENERAL NOTES
G
ENERAL
N
OTES