Lenze PCM 310 PCMatic Slot Controller - Handbuch (Seite 53)


‚
51
The pin allocation is as follows:
PIN Signal
Signal description
3 Data reference potential DGND
4 Data line low CANL
6 24V external power +V
8 Data line high CANH
9 Data reference potential DGND
The Fieldbus requires a 120 Ohm resistor between the data conductors.
The bus settings are the responsibility of the user.
4.3.4. Device Net
Processor
188EM-32
16 bit with timer interrupt and DMA controller
Memory
8 kB dual port memory
128 kB RAM
512 kB Flash
Device Net
ISO high speed, insulated, 500 kBaud
max. 512 Byte input data
max. 512 Byte output data
Status signals
READY, RUN
The pin allocation is as follows:
PIN Signal
Signal description
3 Data reference potential DGND
4 Data line low CANL
6 24V external power +V
8 Data line high CANH
9 Data reference potential DGND
The Fieldbus requires a 120 Ohm resistor between the data conductors.
The bus settings are the responsibility of the user.