Lenze PCM 310 PCMatic Slot Controller - Handbuch (Seite 57)


‚
55
6. SPECIFICATION FOR PROGRAMMING CABLE
For programming from a PC (RS-232), e. g. when using tools which can run on PCs such as the
STEP5 or IEC1131 programming tools, cables according to the following specification are to be used.
For the use of the PCMatic
®
on a programming device with a TTY interface (20 mA), an appropriate
converter (RS-232 <-> TTY) must be included.
Programming cable for 25-pole PC interfaces
Programming cable for 9-pole PC interfaces
Bridge not required for programming cable for STEP-7