Metrohm 794 Basic Titrino - Handbuch (Seite 104)

3.2. Remote control commands
794 Basic Titrino
100
"Setup", continuation
│ │ ├ .E Error ON, OFF ditto
│ │ ├ .H When “hold" ON, OFF ditto
│ │ ├ .C Continue after "hold" ON, OFF ditto
│ │ ├ .O Conditioning OK ON, OFF ditto
│ │ ├ .N Conditioning not OK ON, OFF ditto
│ │ ├ .Re Request after start ON, OFF ditto
│ │ ├ .Si Silo empty ON, OFF ditto
│ │ ├ .M Entry in measuring point list ON, OFF ditto
│ │ ├ .EP Entry in EP list ON, OFF ditto
│ │ ├ .RC Recalculation of results done ON, OFF ditto
│ ├ .I Changing an I/O input ON, OFF ditto
│ ├ .O Changing an I/O output ON, OFF ditto
│
├ .Graphics Changing the curve output
│ ├ .Grid Grid on curve ON, OFF 3.2.2.98.
│ ├ .Frame Frame on curve ON, OFF ditto
│ ├ .Scale Type of depending axis Full, Auto ditto
│ ├ .Recorder Length of axes
│ │ ├ .Right Length of meas value axis 0.2...0.5...1.00 ditto
│ │ ├ .Feed Length of paper drive axis 0.01...0.05...1.00 ditto
│
├ .PowerOn RESET (power on) $G 3.2.2.99.
├ .Initialise Set default values $G 3.2.2.100.
│ ├ .Select Selection of branch ActMeth,Config,Silo,Calib
│ Assembly,Setup,All ditto
├ .RamInit Initialization of working mem. $G 3.2.2.101.
├ .InstrNo Device Identification $G 3.2.2.102.
├ .Value Input of device identification 8 ASCII characters ditto