Burkert Type 8681 - Handbuch (Seite 16)

16
Hardware and Software Installation
After the firmware update the device configuration will be restored, for that purpose
→
1. Power off the control head (device) / disconnect from power supply
2. Set the switch again to �Komm� at the USB adpater
3. Connect the control head (device) again to the power supply
The firmware update ends automatically
Press button
→
Yes if a Device reset shall be done (see chapter 4.4.2),
otherwise press button No for keeping the current configuration
Check whether the new firmware is displayed at
→
Device Info / Firmware -
otherwise start the Firmware Update again
The Service Programm on the PC can be started directly via the button
→
Start PC client or
leave the firmware update program via button X (Close) after the firmware update
english
Type 8681