Burkert Type 8681 - Handbuch (Seite 9)

9
Hardware and Software Installation
Configuring BlueSerial:
Connect Bluetooth module directly to PC and switch on
→
(connection using 9-pole Sub-D connector and appropriate extension cable)
Start software �BlueSerialConfig_EN_1_18_13.exe”
→
(software is on the CD which is enclosed with the BlueSerial)
Tab
→
settings:
Note/change PIN (this PIN is required to configure the smartphone)
Set the
→
RS232: Bits per sec.: 57600,
Data bits: 8,
Parity: None,
Stop bits: 1,
Flow control: None
Apply
→
AT Commands:
→
As newer versions (from 2.3.0.0) automatically detect the baud rate via Bluetooth, the transmission and
reception of so-called AT commands must also be enabled for these versions (see below: Screenshot)
english
Type 8681