Hach-Lange TENSETTE plus User Manual - Handbuch (Seite 32)

Maintenance
32
12. To push the complete tip cone module back to the handle the tip
ejector button must be in the down position. To position the tip
cone module in the right way use the small fitting ( Figure 4 on
page 33 , item 9 ) at the top side of the tip ejector sleeve and the
same cavitiy in the handle. Press now the handle and the tip
cone module slightly together. Release the tip ejector button to
the up position. Then press the visible part of the cylinder at the
bottom side of the tip ejector sleeve while holding the tip ejector
sleeve (top) until you hear a “click”.
13. Press the trigger to reconnect the piston to drive mechanism.
14. Select READY to return from service mode.
Figure 3 Pipette Handle
1 Tip ejector button 2 Trigger