LumaSense Technologies IGA 320/23 - Handbuch (Seite 15)

IMPAC pyrometer IGA 320/23
15
7.7 Basic settings
Under pyrometer parameters all preset values
can be displayed and modified if necessary. A
changed value is entered immediately in the py-
rometer.
The window pyrometer parameters contain all parameter
settings described in 6, Parameter descriptions / set-
tings.
The open / save button enable to store
and recall own pyrometer configurations.
“1 meas.” shows the current measuring
temperature in the pyrometer parameters
window for approx. 1 second.
“Print” prints this pyrometer parameters window.
With close the setting modus is quit, all displayed values
are already taken over in the pyrometer.
A click on the “Test” icon opens a window that
allows the direct communication with the py-
rometer via the interface commands (see sec-
tion 11, Data format UPP
® ).
After entering an interface command (00 is the
adjusted address ex works, “ms“ is the com-
mand “reading temperature value“) and a click
on “Send“ the following window is opened:
This window already shows the answer of the
pyrometer in
1 /
10
°. The actual temperature read-
ing is 325.7°C.
“Len“ indicates the length of the answered data string, incl. Carriage Return (Chr(13)).
In the lower part of the window the connection with the preset baud rate can be checked. Here the command
was send 500 times with 19200 baud. It has taken 4.56 seconds without transmission errors.