ROTHENBERGER ROWELD P315 W Basic, 400V - Handbuch (Seite 20)

ENGLISH 18
2 Technical data
Pipe welding range Ø (mm) ................................90-315
Pipe capacity ......................................................Pressure stages and SDR series see page 33
Power supply .....................................................400V ~3L - 4200W (Trimmer unit 750W,
heating element 3000W)
Cylinder stroke, max (mm) .................................200
Total cylinder surface (cm²) .................................8,04
Pump capacity (l/min) .........................................0,65 / 1,95
Pressure range (bar) ............................................3-90
Hydraulic oil .......................................................HLP 46
Rotary speed trimmer (min-1) .............................1400 / 193
Idle running speed milling disc (min-1) ...............24
Protection / Protection class .....................................I / IP 20
Noise pressure level dB (A) L
pA
¦ K
pA
..................... 68 ¦ 3
Sound power level dB (A) L
WA
¦ K
WA
.................... 79 ¦ 3
Temperature regulation ......................................electronically controlled
Heating plate – dimension (mm) .........................430x350
Total dimensions (LxWxH, mm) ...........................980x800x1400
Total weight (kg) ................................................520
(
Complete machine with transport case
)
The noise level during operation can exceed 85 dB (A). Wear ear protection!
Measurements found in compliance with EN 61029-1:2010!
3 Equipment function
3.1 Description
The ROWELD P 315 W is a compact, heating element butt-welding machine specially conceived
for use in the workshop.
Because of its versatility, the welding machine “Type ROWELD” can safely manufacture the
following welded joints in PE, PP and PVDF pipes with an outside diameter of 90 - 315mm:
I. Pipe - Pipe
II. Pipe - Pipe bend
III. Pipe - T - piece
IV. Pipe - Pre-welded assembly
V. Segmented pipe bends
VI. T - pieces
VII. Y - pieces
The essential machine components are:
basic machine, basic clamping tools 315mm for pipe, reduction clamping inserts, machining
facility and heating element.
When welding pipe bends, the fitting-clamping tool 55879 left or 55870 right, available as
accessory, and the corresponding reduction clamp inserts are to be used.
When welding pre-welded assemblies, the 4-jaw clamping disc 55880, available as accessory, is
to be used.
For the manufacture of T-pieces, the T-piece clamping device 55227 is to be used.
For the manufacture of Y-pieces, the Y-piece clamping device 55226 is to be used