WIKA CPH6600 - Handbuch (Seite 19)

19 WIKA operating instructions, model CPH6600
14005103.03 11/2012 GB/D
GB
6. Commissioning, operation
to select certain functions is limited and dependent upon what is already selected in the
other display sector. The "NEXT" option is used to change to the second parameter.
Only the resistance thermometer and pressure modes have a second parameter.
Resistance thermometers can be displayed in Celsius or Fahrenheit and for pressure
there are 11 different units.
Within any single display sector, the following modes are available:
P[1] = integrated pressure sensor
[EXT] = pressure with external pressure module
P[1] ST = switch test with integrated sensor
[EXT] ST = switch test with external pressure module
Current functions are only available on the lower display:
mA measurement = current measurement without voltage supply
mA w/24V = current measurement with voltage supply
mA Source = current source
mA sim = mA simulation using an external supply from the instrument under test
VOLT = voltage measurement
RTD = resistance thermometer (in the event a resistance thermometer is connected)
The following table shows which functions are available concurrently.
An "--" in a column indicates that the mode in the active display will not be available for
selection if the mode in that row is in use in any other display sector.
Active display
Other displa
ys
P[1] [EXT] P[1]
ST
[EXT]
ST
mA mA-loop Volt RTD
P[1]        
[EXT]
       
P[1] ST
 
-- -- -- -- --

[EXT] ST   -- -- -- -- -- 
mA   -- --  -- -- 
mA-loop
 
-- -- --

--

Volt
 
-- -- -- --
 
RTD        
6.1.2.3 Accessing other menus
In order to access further menus, select the "MORE" option in the main menu.