JUMO 707020 dTRANS T02 LCD - Four-Wire Transmitter Operating Manual - Handbuch (Seite 69)

31
6 Tips ...
... on operation within the parameter and configuration
levels
H
Pressing the q button to confirm a value entry requires that
a value has previously been modified.
If this is not the case, the confirmation will be interpreted as
a call of the next parameter.
H
If, after an accidental alteration, the value is not to be ac-
cepted, just wait for the time-out of 20sec. Afterwards, the
instrument will automatically jump back to normal opera-
tion, without accepting the alteration.
H
Please check that all entered values are correct. The trans-
mitter itself does not check value ranges.
H
Please note that the programming of the “Teach-in” param-
eter differs from the standard operation.
v See “Teach-in” on page 20.
H
In order to be able to modify the parameters at the configu-
ration level, the configuration level has to be called up when
the display shows the parameter OFFS. If this is not the case,
you can read the parameters, but you cannot modify them.