Lupine Piko 1200 Lumens - 13W - Handbuch (Seite 16)

30 31 Piko Piko
Deut
sc
h
Engli
sh
2 2
Operation SmartCore battery
Audible:
To check the capacity, simply press the touch-
pad once. At first an audible signal will sound,
which is especially useful while using the
battery mounted on a helmet or headband,
to give a quick reading in 20% steps.
Capacity Indicator
Taillight
To run the taillight simply press the touch pad two times and the 5 LEDs will
operate continuously. To switch off the taillight, simply press the pad again.
Moving light:
Press the touch pad three times to activate the moving light. To switch it off
press the button another time.
Example: 3 LEDs steady glow (20 %, 40 %, 60 %)
1 LED blinking (80 %)
Visible:
The visible indicator uses 5 red LEDs. The LEDs can operate in two different
operating states: blinking and continuous. LED meanings: A blinking LED
is indicating a 10% step and a continuously glowing LED a 20% step.
5 x = 100 %
4 x = 80%
3 x = 60%
2 x = 40%
1 x = 20%
= 70 % remaining capacity
Battery voltage
(once per Volt)
Battery voltage
(once per 1/10 Volt)
After connecting the lamp to the battery, the software runs a selftest; the
lamp itself as well as the red and blue LEDs in the switch light up once.
The battery voltage is then indicated by the blue and red LEDs, as follows:
 The blue LED flashes once for each volt; and then
 the red LED flashes once for each 1/10 of a volt.
To display the battery voltage again, unplug the light from the battery
and then plug it in again.
Note: To deactivate this display, simply press the button. In other
words, you needn't let the display go through its whole cycle in order
to use the lamp.
The control electronics measures the voltage under load.
Thus, measurements using a voltmeter will not be comparable.
Example: The blue LED flashes seven times and the red LED then
flashes five times; this means that the measured voltage under load
is 7.5 V. This display helps you assess the actual state of the battery
prior to use.
Initialization & voltage display:
battery is fully charged:  more than 8.0 V
battery needs charging or is old:  7.1 to 7.8 V
battery is not ready for use:  6.5 to 7 V
Interpreting the voltage display:
Operation light