Lupine Piko 1200 Lumens - 13W - Handbuch (Seite 20)

38 39 Piko Piko
Deut
sc
h
Engli
sh
Charger Wiesel
3 3
Charging starts automatically. Depanding on the version, the control-LED can go red or only green.
The battery can be left plugged into the charger for an indefinite period. Although this will not dama-
ge the battery, it is not advisable for Li-Ion batteries since they do not require conservation charging.
When kept in a cool place, the annual self-discharging rate for such batteries is 15 %.
LED display:
Plug the included Wiesel charger into an outlet and connect it to the battery.
Connecting:
Charging:
 Warning! This charger is to be used to charge rechargeable Li-Ion batteries only.
It is NOT suitable for charging NiMH batteries!
 Do NOT use non-rechargeable batteries. – Risk of explosion!
 This charger may be opened ONLY by the manufacturer!
Normally the plug contacts are maintenance free. However, if you use your Piko light in salty
environments, it is advisable to apply a thin layer of grease to the contacts every so often to
prevent oxidation. Do NOT use terminal grease or contact spray.
Important! Always disconnect the battery from the light!
Otherwise the small amount of power used by the electronics will discharge the battery, and
the lamp may be switched on accidentally. The consequent uncontrolled heat buildup could
cause a fire or melt adjacent plastic material.
If you intend not to use the lamp for a longer period of time, fully charge and store it at a
cold and dry place.
Important! Because of the delicate sealings, we do not recommend to open the lamp.
A leakage in consequence of opening the light is excluded from warranty!
Plug contacts:
Transport:
Lamp:
Storage:
Opening the light:
After use in salty air, clean the lamp and the cables externally with warm water and some
mild detergent.
Version 1:
LED red on: charging
LED green on: battery is fully charged
Version 2:
LED green on: charging
LED off: battery is fully charged
Product care and storage